Gallet Saint Tropez, Инструкция по эксплуатации

Страница: 35 / 60

– After finishing work and before cleaning, always switch off the appliance and disconnect
it from power supply by taking the power cord connector out of the electric socket.
– The appliance is intended for home use and similar (in shops, offices and similar
workplaces, in hotels, motels and other residential environments, in facilities providing
accommodation with breakfast). It is not intended for commercial use!
– Do not plug the fork of the supply cord into the power outlet and do not unplug the
cord with wet hands or by pulling by the supply cord!
– Never submerge the drive unit under water and do not wash under running water!
– It is not intended for outdoors use.
– Do not place any objects on the appliance.
– The appliance must not be used in damp or wet environment and in any
environment with the danger of fire or explosion (spaces where chemicals, fuels, oils,
gases, paints and other flammable or volatile materials are stored).
– Do not place the appliance on unstable, fragile or flammable surfaces (e.g. glass, paper,
plastic, wooden varnished boards and various fabric/table cloths ).
– When the appliance is switched on for the first time, short and slight smoke can come
out that does not mean any defect and it is not a reason for claiming a defect of the
appliance.
– Use the appliance in the working position only at places with no risk of turning over and
in sufficient distance from heat sources (e.g. heater, stove, cooker, oven, grill), flammable
objects (e.g. curtains, drapes, etc.) and wet surfaces (e.g. sinks, wash basins, etc.).
– It is not permissible to adjust the surface of the extra attachment (e.g. self – adhesive
paper, foils , etc.)!
– Do not use the dryer for other purposes (e.g. for drying textile products, footware , etc.)
than those recommended by the producer.
– Check before every connecting of the appliance to power supply whether switch A1 is in
the 0 position (off) and after drying always disconnect the appliance from power supply.
– When handling the dryer and the accessories (meshes), be careful, they can be
hot!
– Do not carry the dryer if it is hot.
– Holes for air ventilation must not be covered. Do not insert or throw any objects into the
holes.
– Do not put the dryer in operation on soft surfaces (e.g. on a bed, mats, carpets ).
– Prevent entrance of impurities into the appliance (e.g. clouds of dust, hair etc.).
If impurities are sucked and settled inside the appliance, clean it (see par. IV.
MAINTENANCE ).
– When the appliance is overheated, the automatic heat fuse is activated and it
disconnects power supply. If it happens, switch off the appliance and unplug it from
power supply. Then remove possible visible obstacles preventing air flow and let the
appliance cool down.
– Let the appliance cool down before maintenance or storing it.
– Never put the power cord on hot surfaces or do not let it hang over the edge of a table or
a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or
drawing the appliance down and serious injury!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
EN
EN - 35