GB
27 / 35
26
Inserting:
insert the cover
A5
, screw the blender
g
in the opening in the propulsion unit
A
. Proceed
reversely when removing from the propulsion unit.
Notice
–
When working, move the mixer in the container to process the food thoroughly.
–
It is recommended to cut tough ingredients into small pieces.
–
Do not process very hard materials (e.g. ice cubes, etc.). The knife would be blunt soon.
–
Hard ingredients (e.g. legumes, soya beans, etc.) should be soaked in water before processing.
–
The longer you process the food with the blender, the smoother the result will be.
–
If you are not satisfied with the result, switch off the appliance, mix the ingredients with spatula,
take some part of the ingredients or add a little liquid.
stand with rotary bowl (b, D) – for
GALMIX 432
Use:
for whisking and mixing without having to hold the propulsion unit in hand.
Inserting:
place the stand
b
on a suitable working surface (see
I. sAFETY PrEcAUTIONs
). Fasten
the desired accessory
E
into the propulsion unit
A
or
F
. Put the mixer
A
on the bracket
b1
so that the
toothing on the accessory fits in the toothing in the bracket and then push the mixer all the way till it
fits closely into the depression in the bracket (you will hear an audible click). Fold out bracket
b1
.
Slide the lid
c
on the bracket. Place the bowl
D
with the ingredients on the stand. Fold the bracket
back only after its arrest has been clicked in.
removing the propulsion unit (A)
– by pressing button
b3
, the arrest will be released and it is then
possible to remove the propulsion unit
A
from the fold-out bracket
b1
.
V. MAINTENANcE
(pic. 6)
Turn the appliance off and unplug the fork of the supply cord after finishing work and before
each maintenance! Do not use rough and abrasive cleaning agents
(e.g. sharp objects, scrapers, diluents or other dissolvents)!
To clean the propulsion unit
A
and
stand
b
use soft damp cloth with soap. Make sure that water does not get to the inner parts. Wash
other accessory immediately after use in hot water with soap, rinse with clean water and wipe dry
(you may use the dishwasher – not for the blender
g
). The end with the thread of the blender
g
must
not be immersed during cleaning. Work very carefully when cleaning the blender, the knife is very
sharp! Make sure that the cutting edges of the blender do not come in touch with hard objects that
blunt them and thus decrease their effectiveness.
Some foods may discolour the accessory. This has, however, no effect on the functions of the
appliance and is no reason to take the appliance back. This discoloration usually disappears with
time. Never dry the plastic die-cast over a heat source (e.g.
stove, cooker, radiator
).
storing the appliance and accessory
Wind the supply cord
A6
over the rear part of the propulsion unit
A
. Store the propulsion unit in a dry,
dustless place, out of reach of children and persons sui juris.
VI. TEcHNIcAL DATA
Voltage (V)
specified on the type label
Input (W)
specified on the type label
Weight of drive unit (kg) about
1.15
Protection class of the appliance
II.
Size of the product (mm)
200 x 150 x 90
Input in off mode is
< 0,50 W
Содержание GALMIX 232
Страница 2: ...2 5 T u r b o 4 3 CLICK CLICK 1 CLICK CLICK 5 1 H...
Страница 40: ......
