gala gar 463.00.00, Техническое руководство по эксплуатации

Страница: 18 / 42

GALA CUT 700
18
A - GENERAL CUTTING MODE ON FLAT AND CUTTING OF GRIDS.
This is the most general working mode, to cover the cut between the minimum and maximum current margins (20
÷ 100A), use a tip items 7-8 and a two-point spacer system (item 11). For precision contact cutting, an item 6 tip
can be used without a two-points spacer system, we recommend this for thicknesses less than 6 mm with a cutting
current level of less than 40 A.
This type of cutting can be carried out in three ways:
A1) Precision contact cutting, without the need to use the spacer (Tip item 6).
A2) Cutting on flat with spacer for currents of 50-70 (Tip item 7).
A3) Cutting on flat with spacer for currents above 70 A (Tip item 8) ...
Item Reference Description Use
4 1660025 Swirl-Ring Diffuser PT-100 (70 A max.) A1 – A2
6 165124509 Tip 0.9 mm PT-100 (40 A max.) Precision contact cutting I2=30-40 A, e<6 mm
7a 165124610 Tip 1.0 mm PT-100 up to 50 A Cutting with spacer: I2=40÷50 A, e= 6 ÷ 12 mm
7b 165124612 Tip 1.2 mm PT-100 up to 70 A Cutting with spacer: I2=50÷70 A, e=12 ÷ 20 mm
9 1660500 Retaining cap P-100 (70 A max.)
5 1660026 Swirl-Ring Diffuser PT-100 (120 A) A3
8 165124815 Cutting tip 1.5 mm PT-100 Cutting with spacer: I2>70 A, e>20 mm
10 1660501 Retaining cap P-100 (A max.)
11 1660444 Two points spacer PT-100
B - CONTACT CUTTING MODE.
In some applications, it may be necessary to carry out contact cutting, with currents greater 40
A and thicknesses above 6 mm. This may be the case because the maximisation of cutting speed is desired or for
convenience in the torch guidance system. For these cases of contact cutting mode, the consumables KIT will be the
following:
Item Reference Description Use
4 1660025 Swirl-Ring Diffuser PT-100 (70 A max.) e<20 mm max.
5 1660026 Swirl-Ring Diffuser PT-100 (120 A) e> 20 mm
12 165127612 Contact Tip PT- 100 up to 70 A e<20 mm max.
13 165127815 Contact Tip PT- 100 up to 100 A e> 20 mm
15 1660502 Threaded Retaining Cap PT-100
16 1660504 Contact Cutting Protection PT-80/100 70 A max.
17 1660505 Contact Cutting Protection 100A, PT-100
Note: The spare parts are the same as those used in a straight torch for pantograph use.
C- GOUGING WORKING MODE.
This mode allows a very efficient removal of the material. Adjusting the current from 20÷100 A will allow
adjusting the depth of gouging.
Item Reference Description Use
4 1660025 Swirl-Ring Diffuser PT-100
14 165127822 Gouging Tip PT-100
15 1660502 Threaded Retaining Cap PT-100
18 1660508 Gouging Protection PT-80/100