Gaggenau WM262700, Инструкция по использованию и уходу / Руководство по установке

Страница: 17 / 56

17
Installation instructions
en-us
Importance of installing on a solid, level
floor
Your new Gaggenau® washing machine utilizes high spin
speeds to achieve superior water removal from your
laundry resulting in reduced drying time. It is important to
install your washing machine on a floor that will provide
firm support. This prevents the washer from experiencing
excess vibration during spinning that could cause the
washer to move or be noisy.
The installation surface must be solid and level in both
directions. Avoid installing your washer on soft surfaces
such as floors with carpet or foam backed covering
material.
If installing the washer on a wooden floor, observe the
following:
▯
install the washer in a corner for better support if
possible.
▯
if necessary, reinforce the floor by screwing a water
resistant wooden board to the floor (minimum of
1.18 in./30 mm thick).
Remove the transport bolts
9
CAUTION
Damage to the appliance or injury possible
▯
The machine is secured for transport with
transport bolts.
Transport bolts that are not removed can
damage the drum during operation of the
machine, the washer will vibrate, and it will be
much noisier during spin cycles if the transport
bolts are not removed before use.
Be sure to remove all 4 transport bolts
completely before first use. Keep the transport
bolts.
If a pedestal was purchased with the washer, it
must be installed first, prior to removing the
transport bolts. Please consult the pedestal
installation instructions.
▯
In order to prevent transport damage during
later transport, be sure to re-install the bolts
before transport.
1.
Remove drain hose from all brackets.
2.
Loosen and remove all 4 transport bolts.
Remove the sleeves. Take the power cable out of the
brackets.
3.
Place covers over the transport bolt holes.
Four plastic covers are provided in the small parts bag
included with your washer. Separate these covers and
install one in each hole where the transport bolts were
removed.
Lock covers firmly by pressing on the snap hook.
NOTICE
Keep the assemblies together and store them for later
use such as when moving the washer.