Gaggenau WM262700, Инструкция по использованию и уходу / Руководство по установке

Страница: 50 / 56

50
en-us
Troubleshooting
Water does not appear
to be filling into the
washer or detergent is
not dispensed from
detergent tray. A
(Start/Pause)
not pressed. Press A
(Start/Pause)
.
Water taps not turned on. Turn on water taps.
Supply hose kinked or pinched
(reduce flow). Eliminate the cause.
Water supply hose strainers
clogged. Clean the water inlet strainers.
Water pressure too low. Eliminate the cause.
Water cannot be seen
in the drum. The water level in your high
efficiency front load washer is below
the visible part of the drum, this is
normal. No action needed.
Water has not drained
completely. Suds may be excessive (usually due
to too much detergent or non-HE
detergent being used). Use less detergent for future loads. Be sure to use only
high efficiency HE-detergents.
Pump is blocked. Check and clean the drain pump, water drain hose and/
or the drain pipe.
Drain hose or drain pipe is blocked. Clean drainage pipe and/or drainage hose.
Water is coming out
from underneath the
washer. Water supply hose is leaking: is not
screwed on tight at both ends, or
rubber washer not placed in hose. Eliminate the cause: tighten the hose (by hand at the
washer end), check for rubber washer in place.
Drain hose is leaking. Check the drain hose, be sure that it is on the washer
securely with the clamp in place; replace the drain hose
if leaking continues.
Foam comes out of the
detergent dispenser
drawer. Too much detergent was used, or a
non-HE detergent was used; pump
was not able to pump out the
increased suds.
Å displays at end
of cycle.
Immediate fix: mix 1 tablespoon of fabric softener with
1/2 liter (1 pint) of water and pour this mixture into the
detergent compartment, except if there is waterproof
type textiles in the load then do not use softener to
reduce the foam.
To prevent: use less detergent for future wash loads.
Repeated spinning. The Unbalanced Load Detection
system is attempting to balance the
load through repeated spin cycles. To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
No spin took place
(laundry is still wet). Load size too small. Add more laundry.
Large items may have become
entangled in the drum and could not
be distributed by the Unbalanced
Load Detection system; spin cycle
therefore canceled for safety
reasons. To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
Excessive suds: too much detergent
was used, or a non-HE detergent
was used.
Å displays at end of
cycle.
Immediate fix: mix 1 tablespoon of fabric softener with
1/2 liter (1 pint) of water and pour this mixture into the
detergent compartment, except if there is waterproof
type textiles in the load then do not use softener to
reduce the foam.
To prevent: use less detergent for future wash loads.
No Spin was selected. Select a spin speed setting (Low, Medium or High).
Detergent residue on
the laundry. Some phosphate free detergents
contain water insoluble ingredients
that may appear as light spots on
the laundry. Brush off when laundry is dry or
execute the program
RINSE
.
Problem Possible cause(s) Solution(s)