Gaggenau CV282110, Инструкция по эксплуатации

Страница: 30 / 52

30
en
Automatic functions
▯
The cooking sensor function is made available once
the temperature sensor has been connected to the
control panel correctly.
▯
If there is a fault with the temperature sensor, the
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– You did not press the
¨
symbol on the
temperature sensor within 30 seconds of
selecting a hotplate.
– The battery in the temperature sensor has run
out.
Reset the wireless temperature sensor and follow
the connection procedure once again.
▯
If the temperature sensor and the control panel are
not connected correctly due to a transmission error,
follow the connection procedure once again.
If no connection can be established, inform the
after-sales service.
Resetting the wireless temperature sensor
1 Touch and hold the
¨
symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the
LED lights up for the third time, it will start to reset
the temperature sensor. At this point, you will need
to lift your finger off the symbol.
Once the LED goes out, this means that the
wireless temperature sensor has been reset.
2 Repeat the connection procedure from point 2.
Programming
The hob must be on.
1 Attach the temperature sensor to the cookware, see
section
~
"Preparation and maintenance of the
wireless temperature sensor"
2 Place the cookware with sufficient liquid in the
middle of the desired element and always put a lid
on.
3 Select the required hotplate using the twist knob.
‹
appears in the display for the heat setting.
4 Press the
¨
symbol in the control panel. An audible
signal sounds. The
¨
symbol lights up in the
display for the hotplate.
5 Press the
¨
symbol on the wireless temperature
sensor on the cookware. Once the wireless
temperature sensor has been detected, the default
temperature of 95 °C lights up in the hotplate
display.
6 Set the required temperature using the twist knob.
The temperature can be changed by increments of
5
°C.
7 The hotplate display shows the progress of the
heating process from
¬
to
ª
and flashes alternately
with the set temperature. Once the set temperature
has been reached, an audible signal sounds and
the heating indicator goes out. The selected
temperature will then be displayed again.
8 Once the signal has sounded, take the lid off and
add the food. Keep the lid on during cooking.
Note: Do not cover the pan when using the "Frying
with a large amount of oil in the saucepan" function.
You can also activate the cooking sensor function via
the wireless temperature sensor. Proceed as follows:
▯
Set down the cookware and press the
¨
symbol on
the wireless temperature sensor.
▯
Select the hotplate using the twist knob.
When the function is ready, the default temperature of
95
°C is displayed.
Switching off the cooking sensor function
You can deactivate this function in a number of ways:
▯
Select the hotplate and touch the
¨
symbol.
▯
Select the hotplate and set the temperature to
‹
using the twist knob.
▯
Press the
¨
symbol on the wireless cooking
sensor.
A signal sounds and the
¨
symbol goes out in the
hotplate display. The function is deactivated.
X|
Y|
Â
X|
Y|
Â