Gaggenau CV2821.1, Инструкция по применению

Страница: 35 / 40

Troubleshooting
en
35
28.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not
working. The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
The touch fields for
the ventilation func-
tions do not light up. The control for the motor does not work.
▶
Call the after-sales service.
→
"Customer Service", Page 36
The ventilation is not
working. The motor or the control are defective.
▶
Call the after-sales service.
→
"Customer Service", Page 36
The symbol lighting is
not working. The control unit is defective.
▶
Call the after-sales service.
→
"Customer Service", Page 36
​⁠ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠
The odour filters are saturated.
▶
Replace the odour filter. → Page 30
The saturation indicator lights up even though the odour filter has been replaced.
▶
Reset the saturation indicator. → Page 31
No display The power supply has been disconnected.
▶
Use other electrical appliances to check whether a short circuit has occurred in the
power supply.
The appliance has not been connected in accordance with the circuit diagram.
▶
Ensure that the appliance has been connected in accordance with the circuit diagram.
Electronics fault.
▶
If the fault cannot be eliminated, inform after-sales service.
An audible signal
sounds. The control panel is damp or an object is covering it.
▶
Dry the control panel or remove the object.
​⁠ ​⁠/ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠/ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠
The electronics have overheated and have switched off the corresponding cooking zone.
1.
Wait until the electronics have cooled sufficiently.
2.
Press any of the hob's touch fields.
​⁠ ​⁠/ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠/ ​⁠ ​⁠ ​⁠ ​⁠ ​⁠
The electronics have overheated and all of the cooking zones have been switched off.
1. Wait until the electronics have cooled sufficiently.
2.
Press any of the hob's touch fields.
​⁠ ​⁠ + heat setting and
signal tone
There is hot cookware near the control panel. There is a risk that the electronics will over-
heat.
1.
Remove the cookware.
2.
Wait a few seconds.
a
The fault display goes out.
3.
Continue cooking as usual.
​⁠ ​⁠+ audible signal
There is hot cookware near the control panel. To protect the electronics, the cooking zones
have been switched off.
1.
Remove the cookware.
2. Wait a few seconds.
a
The fault display goes out.
3. Continue cooking as usual.
​⁠ ​⁠/ ​⁠ ​⁠
The cooking zone has overheated and it has been switched off to protect the work surface
1.
Wait until the electronics have cooled sufficiently.
2.
Switch on the cooking zone again.
​⁠ ​⁠
The cooking zone has been operating continuously for an extended period. Automatic
switch-off is activated.
▶
Observe the information on automatic switch-off → Page 25 .