Gaggenau CI 294, Инструкция по эксплуатации

Страница: 50 / 60

50
en
Cookware check
t
Cookware check
Cookware check
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1 With the cookware still cold, fill it with approx.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely
matches that of the base of the cookware.
2 Go to the basic settings and select the
™ˆ
setting.
3 Touch the control panel.
A
will flash on the hotplate
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear in the hotplate display.
Check the result using the following table:
To reactivate the function, turn the twist knob.
Notes
– The flexible cooking zone only counts as a single
cooking zone; place no more than one item of
cookware on it.
– If the diameter of the cooking zone that is used is
much smaller than the diameter of the cookware,
only the middle of the cookware can be expected to
heat up. This may result in the cooking results not
being as good as expected or not being
satisfactory.
– You can find information on this function in the
section entitled
~
"Basic settings"
.
– You can find information on the type, size and
positioning of the cookware in the sections entitled
~
"Induction cooking"
and
~
"Flex function"
.
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
X|
É
Y| [|
\|
Z|