GADLEE GT85 B70, Руководство оператора

Страница: 23 / 60

ENGLISH
13
and rotates the brushes.
6.2 Installing and adjusting the squeegee
The squeegee (fig. B, ref. 6) is responsible for the first phase of drying.
To mount the squeegee on the machine, proceed as follows:
1) Make sure the squeegee mount (fig. B, ref. 6)
2) insert the sleeve of the suction hose (fig. E, ref. 1) fully into the squeegee;
3) slacken the two knobs (fig. E, ref. 3) at the centre of the squeegee;
4) insert the two threaded pins into the slots on the support
5) fix the squeegee by tightening the two knobs (fig. E, ref. 3)
The squeegee blades scrape the film of water and detergent from the floor and prepare
the way for perfect drying. With time, the constant rubbing makes the edge of the blade in
contact with the floor rounded and cracked, reducing the drying efficiency and requiring it
to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear
blade bends during operation by about 45° with respect to the floor at every point. Adjust
the angle of the blade during operation by regulating the height of the two wheels
positioned behind the squeegee.
6.3 Moving the machine
To displace the machine do as follows:

Insert the key to release the emergency button (fig. A, ref. 1);

Lift the squeegee;

Switch off the brush function by pressing the main switch (fig. A, ref. 8), led offs;

Select forward or reverse by direction switch (fig. A, ref. 9),and press the
brush/traction button (fig. B, ref. 7), the drive motor is switched on and the machine
will begin to move;

Adjust the running speed via the potentiometer (fig. A, ref. 10);

Once you have reached your destination. Release the brush/traction button to stop
move.
6.4 Mounting and changing the brush/abrasive disks
 IMPORTANT
Never work without the brushes and abrasive disks perfectly installed.
Automatic brush connection
With the head raised and the machine off, place the brushes under the head(Fig M),
making sure they rest against the centring devices to align them with the attachment
assembly. Start the machine by turning the key switch(fig. A, ref. 1) and press the main
/brush connect button (fig. A,ref. 8). When the button is pressed, the LED flashes until
the attachment operation is complete.
Automatic brush release
Stop brush rotation and turn the suction motor off, then press the brush release button
(fig. A, ref. 7). The machine performs the release operation (LED flashing).
6.5 Detergents - Use
 IMPORTANT
Always dilute detergents according to the supplier’s instructions. Do not use
sodium hypochlorite (bleaching solution) or other oxidizers, especially if in high