GADLEE GT85 B70, Руководство оператора

Страница: 21 / 60

ENGLISH
11
 IMPORTANT
Before opening the upper tank: ensure that the recovery tank is empty; ensure that
the emergency button is pressed.
5) insert the batteries in the compartment, orienting them as shown in the drawing
printed on the solution tank in the compartment.
 IMPORTANT
Install the storage batteries on the machine using suitable means according to their
weight.
Positive and negative poles have different diameters.
6) Referring to the arrangement of cables shown in the diagram (fig. D), connect the
battery cable and bridge terminals to the battery poles.
Arrange the cables as shown in the diagram (fig. D), tighten the terminals on the
poles and cover with Vaseline.
7) Lower the tank into the working position and hook it to the solution tank by means of
the fixing hook (fig. B, ref. 10);
8) use the machine in compliance with the instructions written below.
5.4.3 Batteries: removal
!
DANGER
When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
follows:

Disconnect the battery wiring and bridge terminals from the battery poles.

If necessary, remove the devices fixing the battery to the base of the machine.

Lift the batteries from the compartment using suitable lifting equipment.
5.5 The battery-charger
 IMPORTANT
Never let the batteries run down excessively, as they could become damaged
irreparably.
i INFORMATION
If the machine has an ON-BOARD battery charger (installed by the manufacturer),
no operations are required as it will already be ready for use.
5.5.1 Choosing the battery-charger (machines without ON-BOARD battery charger)
Check that the battery-charger is compatible with the batteries to be charged:

Tubular lead batteries : an automatic battery-charger 24V - 25A is suggested. Anyway,
refer to the Manufacturer and read the relative manual to confirm your choice;

Gel batteries : use a battery-charger specifically intended for this type of storage
batteries.
5.5.2 Preparing the battery-charger
If you wish to use a battery-charger not supplied with the machine, it is necessary to
mount on it the connector delivered with the machine (see paragraph “Unpacking” of this