GADLEE GT85 B70, Руководство оператора

Страница: 29 / 60

ENGLISH
19

Clean the collection tank float, taking care not to direct the water jet directly against the
float;

Remove the suction motor air filter from the float support (fig. G ref. 1) inside the
collection tank at the top;

Clean the filter with running water or the detergent used on the machine;

Dry the filter thoroughly before replacing it in the support. Make sure the filter is
correctly located in its housing;

Close the collection tank cover (fig. G, ref. 2).
9.2.2 Detergent solution filter: cleaning

Before cleaning the filter, close the tap (fig. H ref. 2) upstream of the filter.

Unscrew the filter cap (fig. H ref. 1);

Remove the filter from its housing by pulling downwards;

Clean the filter with running water or the detergent used on the machine;

Replace the filter in its housing

Screw up the filter cap
9.2.3 Squeegee blades: replacing
The squeegee blades collect the film of water and detergent from the floor and prepare
the way for perfect drying. With time, the constant rubbing makes the edge of the blade in
contact with the floor rounded and cracked, reducing the drying efficiency and requiring it
to be replaced.
Turning or replacing the rear blades:

Remove the squeegee (fig. B ref. 6) from its support by completely unscrewing the two
knobs (fig. E ref. 3)

Remove the sleeve of the suction hose (fig. E, ref. 1) from the squeegee;

Unscrew the nuts (fig. I, ref. 2);

Release the clip (fig. I, ref. 3);

Remove the two blade retainers (fig. I ref. 4)

Remove the blade (fig. I ref. 5);

Reuse the same blade by reversing the edge in contact with the floor until all four
edges are worn out, or replace with a new blade, fitting it onto the screws on the body
of the squeegee);

Replace the two blade retainers (fig. I, ref. 4) and screw up the nuts (fig. I, ref. 2)

Fix the clip (fig. I ref. 3);
Replace the squeegee in its support following the instructions in paragraph 6.2.
Turning or replacing the front blades:

Remove the squeegee (fig. B ref. 6) from its support by completely unscrewing the two
knobs (fig. E ref. 3)

Remove the sleeve of the suction hose (fig. E, ref. 1) from the squeegee;

Unscrew the nuts (fig. J, ref. 2);

Remove the blade retainer (fig. J, ref. 3)

Remove the blade (fig. J, ref. 4);

Reuse the same blade by reversing the edge in contact with the floor until all four
edges are worn out, or replace with a new blade, fitting it onto the screws on the body
of the squeegee);

Replace the two blade retainers (fig. J, ref. 3) and screw up the nuts (fig. J, ref. 2)
Replace the squeegee in its support following the instructions in paragraph 6.2.
9.3. Regular maintenance
9.3.1. Daily operations