3
Cleaning Procedure
This machine uses hot fluid under pressure. Check the security of all hoses and connections before
operation. Always wear safety glasses, gloves, and protective clothing. If you get ATF in your eyes or on
your skin, rinse with water immediately.
Please Note: You may not have every option mentioned in the
instructions. If you do not, please ignore that step.
1.
Plug the flusher into a 110 V (20 amp) grounded electrical outlet.
2.
Always cycle the
heater
toggle to the ‘on’ position first. The green light will come on. If the red light
is lit, then the tank is low on fluid and there will be
NO
power to the heater. Do NOT overfill the tank.
Allow approximately 15 minutes for the flusher to reach operating temperature of
above
150°
Fahrenheit.
3.
Install the appropriate quick disconnect line adapters (imports or domestic) to the ATF cooler inlet and
outlet lines using any of the three methods in Picture 1. (To forward flushing only) Connect the red
pressure hose to the cooler
inlet
line (the line going to the external filter). Connect the blue return hose
to the cooler
outlet
line (the line coming from the vehicle’s cooler tank going to the transmission).
WARNING
Improper use of this machine can result in burns and other
serious injuries.
Always wear eye protection and protective clothing and follow
all instructions in this booklet.
ATTENTION
Make sure the outlet has no other appliances (light fixtures, drop lights,
extension cords, etc) plugged into it. Also NEVER plug the flusher into an
extension cord or drop light cord; you would damage the unit. Always
make sure the fluid purge handle is in the ‘flush’ position to avoid
accidents, and make sure the filter screens are in place.
Picture 1
