2
…unless these instructions are followed.
Your new Turbo Tank Flusher is covered against factory defects by a limited 90-day warranty from the date of
invoice. This warranty does not apply to any products damaged by improper installation, shipping accidents,
misuse, alteration or repairs not performed or authorized by G-TEC.
The following instructions MUST ALWAYS be followed:
•
NEVER plug the flusher into a wall outlet that has any other 110 volt appliances using that
circuit including but not limited to light fixtures, drop lights, extensions cords, etc.
•
ALWAYS check the position of the fluid purge valve before operating the flusher to prevent
fluid spills.
•
Before starting or engaging the motor for flushing and purging, be CERTAIN that the ATF in
the tank has reached ABOVE 150 degrees.
•
If the RED INDICATOR LIGHT is
on
, the ATF level is
too low
in the tank and the heater WILL NOT
HEAT. Refill the tank.
•
Heater is adjustable; however, doing so is solely at the risk and responsibility of the operator. Adjusting
to a higher heat is only recommended on a per need basis. After each high temperature job, the heater
should be turned back to the factory setting of approx. 150-160°. Never leave the heater adjusted to a
high temperature!
•
If the temperature ever exceeds 198 degrees, the float is designed to melt causing permanent loss of
power to the heater until the float is replaced.
•
The Baldor Motor/Viking Pump is equipped with a Watts Pressure Relief Valve. The factory setting is
between 100-125 psi. You must never raise the psi higher than 125 as this will cause damage to the
motor and pump.
•
G-Tec’s complete warranty and all liabilities are VOID if mineral spirits or petroleum-based
solvents are used in your Turbo Tank Flusher!
This unit will not work…
Disclaimer
G-TEC is not responsible for any damages to the flusher or to the customer’s facility or to operators when the
instructions and warnings are not followed or heeded. All repairs or replacements will be at the customer’s expense.
