After setting up all parameter, press and hold 'ENTER' button for more than three seconds
to go for the next step. The display will show you the choice of options which are charge or
discharge.
Press 'UP' or 'DOWN' button to select 'Charge' or 'Discharge', and press 'INC' or 'DEC'
button to choose a sub-program to be performed. To start the process, locate the cursor at
the sub-program to be performed then press and hold 'ENTER' button for three seconds.
- Charge 'Balance':
This is for balancing the voltages of each individual cell of battery
pack to be charged. To do this, the battery pack being charged should have the individual
cell connector. And connect it to the individual port at the right side of charger with a
suitable connection adaptor that fits with your battery. And also, you should to connect the
battery ordinary charging mode. The internal processor of the charger will monitor the
voltages of each cell of the battery pack and controls the charging current that is feeding to
each cell to normalize the voltage.
- Charge 'Storage':
This is for Lithium battery not to be used for long time. The program
will determine to charge or discharge the battery to a certain voltage depending on the
voltage of the battery at its initial stage. The final voltages are different from type of
batteries, 3.6V for Lilo. 3.7V for LiPo and 3.3V for LiFe per cell. If the voltage of battery at
its initial stage is over the voltage level to storage, the program will start to discharge.
- Charge 'Fast':
The charging current is getting smaller as the process goes to the near
end term of Lithium battery charging. To finish charging process earlier, this program
eliminate certain term of CV process. Actually, the charging current will goes to 1/5 from
the initial value to end the process while the normal charging goes to 1/10 during CV term.
The charging capacity may be a bit smaller than normal charging but the charging time will
be reduced.
- Discharge ' Normal':
The charger will keep on discharging with the discharge current
continuously until the discharge voltage has been reached.
- Discharger 'CV-mode':
The discharging current will be decreased gradually until the end
current which has been set up at 'End current' has been reached, when the voltage has
been dropped to the final discharge voltage. For maximum discharge , use this mode.
7.2 Select program and start the process
LiPo [1] 3Cell(11.1V)
Ev: 12.60V Ec: 2500mAh
CHARGE
D-CHARGE
[Normal]
[Balance]
LiPo
[1] 3C
2500mAh
START
ENTER
Chg current: 2.0A
Dchg current: 3.0A
Dchg voltage: Default
End current: Auto
Chk time: 10min
Safety temp 50C
Read Vol: 3C/12.50V
Manual of the charger E6D
10
It is very important to know the exact type of battery to be charged, nominal voltage and
capacity. Not to know these facts is the reason why batteries are damaged and improperly cared for.
Read the batter's label and instruction sheet carefully, or consult the battery supplier to get those facts.