G.T.Power C6D Pro, Руководство пользователя

Страница: 21 / 28

31
PWMIn Ous
65.53ms/15.25 Hz
Warmer 68 ℃
012:00 80W
13.4 PWM IN introduction
This program can be used to test the pulse width value of
other equipment. Connect the servo tester to the 3pin
temperature sensor port can measure the pulse width and
frequency of PWM directly.
PWMOut AUT-1
10.0ms 138
13.5 PWM OUT introduction
Connect the servo with 3pin temperature sensor port can test
the servo parameters.
AUT-1
，
AUT-2
，
AUT-3 indicate three different speed automatic
mode, MAN is manual mode, THR is three position mode(
including the maximum position, the middle position, the
minimum position). Then set PWM periodic value, normally
the value is 50HZ(20MS), PWM value
（
Only need to set the
min. Value and the max. Value under auto mode.
）
Short press Start/Enter to start the program, through press
INC/DEC to set heating temperature, heating time, heating
power.
Heating temperature 30°-100°, heating time 1-120 minutes,
heating power 10-100W.
After finished, long press ENTER to test interface. If need
re-set parameters, short press STOP back to set interface.