6
Pre Installation set up and testing
Handset remote
receiver trigger
wires
Motor wires
Battery
Wires
Battery connection for bench testing
and set up
Limit switch
wires
SL DC2 GATE MOTOR
INSTALLATION AND SET UP
INSTRUCTIONS
Black / Blue
wire to
Black
battery
terminal
Red
wire to
Red
bat-
tery terminal
Handset remote
receiver power
wires
Gate Direction LED’s
Open GREEN LED
Close RED LED
12 v Transformer Wires
© 2012 G Force Automatic Gates All Rights Reserved
Refer to the “
SL DC2 Circuit Board”
data sheet included with this manual and locate battery connection
wires on the circuit board. Connect the battery wires to the battery terminals on the battery. Note the po-
larity (
Red
wire to
Red
battery terminal,
Black / Blue
wire to
Black
battery terminal). The board
should now be powered and great care should be taken to avoid shorting out or otherwise damaging the
circuit board. Green and Red gate direction LED”s will flash when power is connected.
Activate the gate motor using one of the handset remote. The remotes are coded to the gate motor dur-
ing assembly. Alternatively, refer to the “
Handset Remote Programming”
data sheet to code in the re-
motes. Press the remote again to stop the motor. Press the remote again to reverse the motor direction.
Disconnect the battery wires when finished.
We recommend the gate motor settings and direction of rotation be set up and tested prior to
installation.
Un pack the motor and remove the motor cover. Place the gate motor on a suitable work bench.
Visually inspect the motor to ensure nothing has moved during transit. Refer to the “
SL DC2 Circuit
Board”
data sheet included with this manual and familiarise yourself with the layout and location of the
items and wiring terminals
