12
The solar panel is to be connected directly to the terminal block next to the regulator and NOT
to the circuit board.
Remove the “Dummy” wires and connect the positive and negative solar panel wires to the
terminal block (grey / red positive wire - grey / black negative wire) from the regulator. Plug the
piggy back spade connections to the battery terminals on the battery. Note the polarity (
Red
,
Positive wire to
Red
battery terminal,
Black / Blue
Negative wire to
Black
battery terminal). The
board should now be powered and great care should be taken to avoid shorting out or otherwise
damaging the circuit board.
1.5mm Twin Active Low Voltage Cable
(
RED
active / WHITE neutral)
Terminal Block
Solar Panel Wires
RED
wire to
RED
(Positive) wire
BLACK
wire to
NEGATIVE
wire
Weather Proof
Enclosure
Terminal Block
Solar Panel Wires
POSITIVE
wire to grey /
red
wire
NEGATIVE
wire to grey /
black
wire
(Remove “Dummy Wires”
before connecting solar
panel wires)
Red
wires to
Red
Positive Battery
Terminal / Piggy Back Spade
Connectors.
Black / Blue
wires to
black
Negative battery Terminal /
Piggy Back Spade Connectors
Solar Regulator
Indicator LED’s
Safety
Fuse
SL DC2 Solar Panel /
Regulator Wiring
Instructions
If the solar panel wires need to be extended then we recommend you use a terminal block /
joiner. Place the terminal block / joiners into a small enclosure for protection and outdoor
installation.
grey / red positive wire /
grey / black negative wire
© 2012 G Force Automatic Gates All Rights Reserved
