Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev18
80
•
Check the oil level regularly during work. Never
let it run out!
•
Clean the tank cap and its surroundings so that
no dirt falls into the tank.
•
Place the device so that the tank cap is facing
upwards.
If the oil level in the tank does not drop, there may be a problem in the oil supply:
Check the lubrication condition of the chain, clean the oil lines, and contact your dealer if
necessary.
Checking the lubrication of the chain
The chain saw must always fling a small amount
of oil from itself.
•
Always check the lubrication of the chain
and the oil level in the tank before
starting work.
Never use your saw without lubricating oil. If the chain dries out, the entire cutting tool
will be permanently damaged in a short time.
Each new chain must be run in for 2 to 3 minutes. Then check the chain tension and
adjust it if necessary (see section "Checking the chain tension").
Using the branch saw attachment
Preparation
•
Wear suitable protective clothing and equipment - see "Safety Instructions."
•
Start the engine
•
Put on the shoulder strap
Do not throw the cuttings into the household waste, they can be composted!
Never stand under the branch you are sawing off. Watch out for falling branches and
twigs. Be aware that they could hit you after impact.
Cutting procedure
Always cut the lower branches first so that they can fall down freely. Cut thick branches
in small, controllable portions.
Working posture
Hold the wrap-around handle with your left hand and with your right hand the throttle
handle. Your left arm should be stretched out in one of the most comfortable positions
for you.
