77
Common function
● Y o u c a n h e a r t h e
Altitude data through an
earphone or headset,
by Activating the Speech
function.
ALTITUDE
(ALARM) (VIB) (LIMIT)
UP▶INH ▶OFF ▶ +200
DN▶INH ▶OFF ▶ -50
REFERENCE▶ EXEC
SPEECH▶ INH SW▶ NULL
0 m
0 / 0
MIN/MAX=
ALTITUDE is a screen which displays / sets up
the altitude information from an optional altitude
sensor or GPS sensor. The altitude of the model
which is flying can be known. If it becomes higher
(low) than preset altitude, you can be told by alarm.
To show warning by vibration can also be chosen.
Data when a power supply is turned on shall be 0
m, and it displays the altitude which changed from
there. Even if the altitude of an airfield is high,
that shall be 0 m and the altitude difference from
an airfield is displayed. This sensor calculates the
altitude from atmospheric pressure. Atmospheric
pressure will get lower as you go up in altitude,
using this the sensor will estimate the altitude.
Please understand that an exact advanced display
cannot be performed if atmospheric pressure
changes in a weather situation.
● Conversion of a display unit is performed by
"TELEMETRY
UNIT"
of
"PARAMETER"
.
●Select [ALTITUDE] in the TELEMETRY screen and access
the setup screen shown below by press the Jog key.
●Altitude
●The maximum and the minimum
when powering ON are shown.
●"DN" indicates the
alarm will start when
the altitude reaches
below your set value.
● " U P " i n d i c a t e s t h e
alarm will start when
the altitude reaches
above your set value.
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Move the cursor to the [REFERENCE] of "EXEC"
item.
3. Press the Jog key (1s or more press).
*Atmospheric pressure is changed according to the weather also
at the same airfield. You should preset before a flight.
Alert set : High side
1. Move the cursor to the UP:(ALERT) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item.
4. Ajust the rate by press the +-key.
Initial value: +200(m)
Adjustment range: -500~+5000(m)
(UP:(LIMIT)
≧
DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
Alert set : Low side
1. Move the cursor to the DN:(ALERT) item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT)[value]item .
4. Ajust the rate by press the +-key.
Initial value: -50(m)
Adjustment range: -500~+5000(m)
(UP:(LIMIT)
≧
DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
*An altitude sensor or GPS sensor must be installed in the aircraft.
ALTITUDE : Display of SBS-01A / SBS-01G(Option), and alarm setup
ON
2 Position
3 Position
OFF
ON
OFF
OFF
●Switch selection
TYPE 1
TYPE 2
TYPE 3
"VIB" type
If the following types are selected, the
transmitter will vibrate during the warning.
● Maximum and minimum date reset
by pressing the
Jog key
for 1 second.