FUTABA 9ZAP - PART2, Руководство пользователя

Страница: 31 / 78

Helicopter Section
THROTTLE CURVE (TCV)
This function programs throttle curves to per-
form hovering, loops, rolls, and other aerobatics in
the different flight modes. The throttle curve sets
the servo response over the full stroke of the
throttle stick by a 13-point curve. The low side
rate can be input (point 7 is the reference). The
servo delay at idle-up and other flight condition
switching can be programmed.
Setting Up The Throttle Curve Function
Throttle Curve Inputting
In the Condition Menu, press the •TCV key to get the
THR CURVE menu shown in the upper portion of the
figure below.
Curve setting
Low Side
Rate Setting
Delay Amount
Setting
Point Movement
To Next Screen
Return To
Condition Menu
To Preceding
Screen
Setting Point Selection (Points 1 to 13)
Press the B key to turn on the curve inputting
function. Use the movement keys Q and R to select the
point whose value is to be set. The PT-> key increases
the point number by one, and the <-PT key reduces the
point number by one. The active point on the curve is
shown as a black dot.
Once you have selected the desired point on the curve,
you may input the rate with the rate setting keys E to
M . The number keys 0 through 100
input the value
directly. The + and - keys increase or decrease the
value by 0.5 with each button pressing (so it takes two
hits to see a number change because of numeric round-
ing).
You may set or reset each point on the curve by
repeating these steps for each point.
Low-Side Rate Adjustment
Press the D key and you may input the rate with the
numeric keys E to M. You may set anywhere in the
range from 0 to 110% (initially the rate is set to 100%).
Delay setting
Shift to the next screen (the lower one in the figure)
by pressing the NXT (P) key. Enter the delay with the
rate setting keys E to M. The delay may be set from 0
to 100%, and is initially set to 0%.
Use the END (N) key to leave this menu.
Helicopter Section, Page 107