FUTABA 9ZAP - PART2, Руководство пользователя

Страница: 72 / 78

Sailplane Section
ELEVATOR-FLAP Mix (E-F)—2-S
This mixing is used to droop the flaps whenever
an up elevator command is given (and may be
set up for down elevator as well, helpful during
'outside' maneuvers). It helps aerobatic aircraft to
make tight, square corners in maneuvers.
Elevator-to-flap mixing can be set up to be
turned on and off during flight by a switch (if no
switch is activated, this mixing remains on all the
time). You can also set the flap trim rate in this
function. If the flaperon function is activated, the
elevators are mixed with the ailerons, otherwise,
the mixing is with the flaps only.
Setting Up Elevator-to-Flap Mixing
Activation of command
In the Condition Menu, press the E->F key to get the
ELE TO FLP menu shown below. Use the A key
to activate mode setting, then press the ACT or INH
keys (F and G) to activate or inhibit Elevator-to-Flap.
Mixing State
Mode setting
Mixing
rate
setting
ON/OFF switch
setting
Trimming volume
setting
Return to Condition
screen
Set Value. Including Volume Adjustment
Mode Selection
Setting the Mixing Ratio - Down and Up Side
You now set the amount of mixing for down elevator
command. Press the C key to activate mixing ratio for
the Down direction and set the value with the numeric
keys E to M . The number keys 0 through 100 input
the value directly. The + and - keys increase or de-
crease the value by 1. The +/- key may be used to
reverse the throw direction. Your setting may vary from
-100 to +100%, the initial value is set to +50%.
Now set the amount of mixing for the up elevator
command. Press the D key to activate mixing ratio for
the Up direction and set the throw with the numeric keys
as before.
On/Off Switch Setting
On initial setting, the activation switch for Elevator-to-
Flap mixing is set as SW C on at the upper position. If
you would like to change the switch or turn mixing on all
the time, call the Switch Setting screen by pressing the
SWT P key. Then use the keys to choose the desired
switch location and on direction. For more information
on the switch setting method, see page 37).
Mixing Rate Trim Volume Selection and Operating
Direction
A mixing rate volume control is not defined initially.
To define one, display the volume setting screen by
pressing the VOL O key. For a description of the
volume setting method, see page 37. The volume control
adjusts ±25% of the set mixing rate.
Use the END ( N) key to leave this menu.
Sailplane Section, Page 148