FUTABA 8US, Инструкция по эксплуатации

Страница: 47 / 99

44
Copying from one model memory to another
To TIMER function
To TH-CUT function
Source to copy
FROM (current
model settings
in memory #1)
MODEL DATA COPY
Select the destination model
number with the (+) and (-)
keys. When you have the
right number, press the (+)
and (-) keys simultaneously.
The confirmation message
"OK?" is displayed.
Data input keys
These keys are used to move through submenus in the MODEL function.
Copy destination
(currently memory
01. Press the (+)
or (–) keys to
change the
number displayed.
"SET" will flash.)
When the (+) and (-) keys are simultaneously pressed again, copying begins.
A continuous tone sounds when the copying is completed. (If you don't
wish to copy models, press the (-) key to halt copying after the confirmation
message. The display then returns to its original state.)
CAUTION: if power is turned off before the end of the continuous tone, data
will not be copied.
The NAME function may be used to assign the current model memory a name.
The model name makes it a lot less confusing since you can easily tell your model
memories apart. The name of the model that you assign is displayed at the top left
corner of the startup screen. The name can be up to six characters long, and each of
the characters may be alphanumeric, space, or symbols (see list below).
The default names assigned by the factory are in the "A:MDL-01" (Model 01)
form. Note that the model type is displayed as the single character that appears
before the model name on the screen. The code used is H = HELI (helicopter), A =
ACRO (aircraft), G = GLID (glider)
Model Naming Instructions
To TIMER function
To TH-CUT function
Model name
(6 characters or less;
current name = "MDL-01")
MODEL NAME ENTRY
Select the desired character
by pressing the (+) and (-)
keys. When you have the
right one, press the (>) key to
move to the next character.
Again hold down the (+) or (-)
key until the desired character
appears at the next slot.
Complete the model name by
repeating this sequence to the
end of your name or six
characters, whichever is less.
Data input keys
These keys are used to move through submenus in the MODEL function.
Allowed Characters
ABCDEFGHIJKLMNOPQRSTUVWXYZ
äöü(space)!"#$%&'()
*+,-./0123456789
Indicates HELI model type