![background image](http://html1.mh-extra.com/html/futaba/8us/8us_instruction-manual_2351455039.webp)
36
HELI SN-3 Type
Use SN-3 Mixing if the servo inputs match the
figure.
With Aileron inputs, the three servos tilt the
swashplate left and right;
With Elevator inputs, the elevator and pitch
servos tilt the swashplate fore and aft;
With Pitch inputs, all three servos raise the
swashplate up and down.
Use the reversing function (REV) as necessary
to get the proper aileron, elevator, and pitch operations.
Aileron
Pitch
Front
Elevator
120
120
120
Choosing the model type
To INVERT or
SWASH
To REVERS
function
Type display
(ACRO, GLID1FLP, GLID2FLP,
HELISWH1, HELISWH2,
MODEL TYPE CHANGE:
Select Model Type with the (+)/(-)
keys – the type name flashes on
and off. Next, press the (+)/(-)
keys simultaneously. At this point,
an "OK?" confirmation message is
displayed. If you press the (+)/(-)
keys simultaneously again, the
model type change is started. A
continuous beep indicates
completion.
*NOTE: if you change the model
type, you'll lose the contents of the
memory. To halt model type
change after the confirmation
message is displayed, press the
(-) key. This will returns you to the
original screen.
NOTE: If the power switch is
turned off while a TYPE change is
underway, the data may not be
reset.
Data input keys
These keys are used to
move through submenus in
the PARA function.
HELISWH4, HELISR-3,
or HELISN-3)
The Modulation menu is used to select the PCM or PPM mode of transmission, to match the
receiver being used (PCM = Pulse Code Modulation, and PPM = Pulse Position Modulation).
When using an FM receiver, you should select the PPM mode. Note that you have to turn
our transmitter on and off before a modulation change becomes effective.
y
Changing your transmitter’s modulation
To INVERT or
SWASH
To REVERS function
Current setting
displayed
(PCM or PPM)
MODULATION CHANGE
Select the modulation mode
with the (+)/(-) keys.
Data input keys
These keys are used to move through submenus in the PARA function.
IMPORTANT: After making the settings above, you'll need to turn
the transmitter power off and on to switch the modulation mode.
Verify that you changed the modulation
mode in the PCM/PPM display.
CAUTION: PCM cannot be operated
in the PPM mode and vice versa.
function
Содержание 8US
