13
Connecting for loads under 100 W
For loads under 100 W, you can use the DC-DC accessory plug cable.
Follow these steps to connect the unit with the DC-DC accessory plug
cable:
1. Place the inverter on a fl at surface such as the fl oor of your vehicle.
2. Make sure that the unit is off by verifying the digital display is off.
3. Connect the ring terminals on the DC-DC accessory plug cable
to the cabling terminals on the unit. (The cabling terminals are
shown in Figure 2.) Fasten the positive (red) ring terminal to the
positive cabling terminal, and then fasten the negative (black) ring
terminal to the negative cabling terminal.
CAUTION: Reverse polarity
Power connections of the 12 V DC battery to the inverter
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
must be positive to positive and negative to negative. A
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
reverse polarity connection (positive to negative) will blow
a fuse in the inverter and may permanently damage the unit. Damage
caused by a reverse polarity connection is not covered by your warranty.
CAUTION:
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
Make sure you connect red to red and black to black, and
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
make sure you screw the nuts on tightly.
4. Tighten the nut on each cabling terminal until it is snug.
Do not over-tighten.
Содержание 2218173
Страница 1: ...DIGITAL INVERTER 400W 2218173 Owner s Guide...
Страница 2: ......
