Furuno FSV-85-MARK-2, Руководство по установке

Страница: 26 / 104

1. HOW TO INSTALL THE SYSTEM
1-18
1.5 Raise/Lower Control Box
The inertial measurement unit is installed in the raise/lower control box. When using
the control box extension box, remove the two fans from the raise/lower control box
and install them in the control box extension box. Install the inertial measurement unit
in the control box extension box, then secure the control box extension box to the hull
unit.
How to attach the raise/lower control box to a bulkhead
When using the control box extension box, the raise/lower control box can only be
installed on a bulkhead. Use 4
×
M10 bolts to fasten the raise/lower control box in po-
sition.
The internal electromagnetic switches only function correctly if the raise/lower
control box is installed in the correct orientation, as shown in the figure below.
Note 1: When installing the inertial mea-
surement unit inside the raise/lower con-
trol box, you must enter the location and
angle of the raise/lower control box for
heading correction. (See section 3.9 for
how to adjust the heading.)
Note 2: The inertial measurement unit
must be installed inside the control box
extension box. The unit is extremely
shock sensitive, take care not to drop it.
Where possible, install the unit after the
control box extension box has been installed.
UP
OK