Furuno FELCOM251, Руководство по установке

Страница: 47 / 122

2. INSTALLING THE SYSTEM
2-34
2. Remove the four screws on the front cover, then remove the cover.
3. Secure the case to the installation location with four 3

10 self-tapping screws
(supplied). See the outline drawing at the back of this manual for the fixing hole
locations.
4. Connect the cables, fabricated at step 1, to the incoming bell's terminals.
5. Fasten the cables to the cable fixture with the cable ties (supplied).
6. The cover of the incoming bell has protective seals on the cable entries. To re-
move the seals, tear along the perforated lines on the inner side of the cover.
7. Reattach the lid to the case with the four screws removed at step 2.
How to attach Splash proof cap
When installing the incoming bell on a bulkhead,
use the optional splash proof cap (Type: 16-023-
5501/Code No.:001-493-320) to help keep water
our of the unit. With the splash proof cap attached,
this unit has an waterproof rating of IP22.
Note: The splash proof cap provides no protection
used if the incoming bell is mounted face upward.
Remove the seal from the splash proof cap and at-
tach the cap as shown in the illustration to the right.
Crimp-on lug
FV1.25-3 (LF)
50
䡉䡉
50
䡉䡉
6 䡉䡉 6 䡉䡉
To modular jack box
Outer shield
Vinyl tape
Cut the vinyl sheath and drain wire
To communication unit To modular jack box
Cable tie
CV-150N Cable tie
CV-150N