Furuno FELCOM251, Руководство по установке

Страница: 28 / 122

2. INSTALLING THE SYSTEM
2-15
How to attach the antenna cable connector N-SP-12DSFA-CF
If the optional coaxial cable 12D-SFA-LITE-CV (100 m) is used, attach the optional co-
axial plug N-SP-12DSFA-CF as follows.
15
10
2
5
30
95
Outer sheath
Clamp nut
Gasket
Clamp
Washer
Clamp nut
Shell
Pin
Solder through
the hole
Trim shield here
Expose the insulator by 2 mm
Expose the conductor (core) by 5 mm
Trim alminun
tape here
Dimensions in millimeters
Heat shrinkable tube or vinyl tape
Inner sheath
Armor Shield
Remove outer sheath and armor by the
dimension shown left.
Remove inner sheath and expose shield
by the dimension shown left.
Remove the insulator beneath shield by
10 mm and expose the core.
Slip on clamp nut, washer, gasket and
clamp as shown left.
Fold back shield over clamp and trim.
Cut alminum tape at four places, 90° from
one another.
Fold back alminum tape over clamp and
trim.
Slip the pin onto the conductor. Solder
them together through the hole on the pin.
Insert the pin into the shell. Screw the
clamp nut into the shell.
Tighten them by turning the clamp nut.
(Do not tighten by turning the shell.)
Twist shield end.