Furuno Felcom 82, Руководство оператора

Страница: 146 / 230

6. 9.6k DATA COMMUNICATIONS
6-14
6.7.2 Basic AT commands
Command
A
A/
D
E
▲
H
Description
Forcibly puts the MES in the ANSWER mode.
If this command is entered when a call arrives, the connection sequence is started.
e.g.: ATA<CR>
Executes the just previously entered command again.
This command is independently used without entering "AT."
You do not need to enter <CR> after "/."
e.g.:
ATxxxxxxxxxxxx (just previously entered command) (i)
...
A/
The command in (i) is executed again.
Sends a call to a remote station with the specified number.
D[dialed character string>]
The following characters may be used for the dialed character string:
0-9 Used to specify the telephone number of a remote station.
( ) and - Used to delimit the telephone number.
# Used to indicate the end of the telephone number (may be omitted).
; Used to return to the command mode after dialing.
e.g.: 1.ATD003-00-81-123456789# (when AT+WLES=000)
123456789 in Japan is dialed for automatic connection via the LES of 003.
2. ATD00-81-123456789 (when AT+WLES is not 000)
The number is dialed via the LES specified with the +WLES command.
The tailing character "#" may be omitted.
3. ATD003-00-81-123456789#;
This is the same as the above 1, except that the MES returns to the com-
mand mode after the number is dialed.
Specifies whether the received command character string is echoed back.
E[<n>]
n=0 Not echoed back
n=1 Echoed back
•
If <n> is omitted, it is assumed as "1."
e.g.: ATE1<CR>
Disconnects the connected line.
H[<n>]
Disconnects the connected data line. If a telephone or facsimile ma-
chine is in use, its communication cannot be cut off. (To cut off the
communication, the MES must be in the on-line command mode.)
Does nothing.
•
If <n> is omitted, it is assumed as "0."
e.g.: ATH<CR>
n=0
n=1