Furuno FCV-2100, Руководство по установке

Страница: 32 / 59

3. INITIAL SETTINGS
3-4
• On: The echo picture for this equipment is displayed on main monitor and the
echo picture for external sounder is displayed on sub monitor. To display the
echo picture on the sub monitor, select the [External Echo Sounder] icon
( ) after selecting the [Display] icon ( ) from the InstantAccess bar
™
.
6. Press the [OK] button to store the setting.
The message “The change has been stored. Restart the system.” appears.
7. Press the [Yes] button to reset the system.
Note: The display resolution setting is required when the monitor type is changed.
3.2.3 KP control and water temperature setting
Set the KP control signals and water temperature for external equipment and sensor.
1. Select [Shared Settings] on the [Service] menu.
2. Set the [TX triggering] for external KP control.
3. Select [Temp Source] to set the data source for water temperature data.
Select the temperature sensor data format from NMEA/ CIF/ External E/S Water
temperature/ External transducer.
4. Select [OK] to close the menu.
3.2.4 Transducer setting
You can increase the accuracy of your fish finder by adjusting transducer parameters.
Adjust the parameters as follows:
1. Select the [Shared Settings] on the [Service] menu.
2. Select the [Transducer Parameter1].
3. Input the information as shown on the data sheets included with the transducer.
The data sheets are attached to the base of the transducer cable.
Do not change the setting for [Transducer Parameter 2] (default: 0.00).
4. Select [OK] to close the menu.
Note: The adjustment must be re-done if the transducer is replaced or the unit factory
default settings are restored.
TX Triggering: On
Trigger Input:
n
(ascent edge) or
p
(decent edge)
Trigger Output: Positive or Negative
External Trigger Display: 0-200 ms (value setting)
Note: External KP levels are follows:
• Input: 5 V to 12 V
• Output: 12 V
• NMEA: Signal from the connected equipment
• CIF: Signal from the connected equipment
• External E/S Water Temperature: Temperature sensor connected to external
sounder
• External Transducer (HF/LF): Temperature sensor in the external sounder’s
transducer, frequency to use
Note: The DFF1-UHD uses a combined transducer. The output data is the same
for both HF and LF in this case.