Furuno FCV-2100, Руководство по установке

Страница: 24 / 59

2. WIRING
2-10
2.2.3 Processor unit cable (LAN cable)
Connect the processor unit with LAN cable (MOD-Z072-050+, 5m). When using the
optional armored cable, peal the external sheath and armor from the cabling. Refer to
the following page for armored cable fabrication.
Note: Do not connect equipment other than the FCV-2102 or HUB-101 to the NET-
WORK port.
1. Open the cover of the transceiver unit.
2. Unfasten the seal nut of NETWORK port and disassemble the seal assembly.
3. Dismantle the seal assembly as shown below.
4. Pass the cable into the seal nut and seal assembly, then insert the cable into the
unit through the cable gland.
5. Set the gasket assembly onto the LAN cable.
6. Pack the gasket assembly into the seal nut.
Seal assembly Seal assembly
Seal Seal
Claw Claw
Seal nut Seal nut
Dismantling the seal assembly
STEP1:
Hold the fat end of the assembly
with both thambs while placing the
index fingernails between the seal
and claw.
Use caution to avoid injury.
STEP 2:
Using the thumbs, gently push
the seal out of the claw.