Furrion F2GWH, Руководство пользователя

Страница: 5 / 33

English
CCD-0005833 Rev: 04-14-22
- 3 -
BEFORE INSTALLATION
This water heater is certified for installation in
Recreational Vehicles (RV’s) and is not for use in Marine
or Space Heating Applications.
The installation must conform to one or more of the
following, as applicable:
1. Local codes or, in the absence of local codes, the National
Fuel Gas Code, ANSI Z223.1/NFPA 54 and/or CSA B149.1,
Natural Gas and Propane Installation Code.
2. Local codes or, in the absence of local codes, Recreational
Vehicles, NFPA 1192 and/or CAN/CSA-Z240 RV Series.
USA AND CANADA - FOLLOW ALL APPLICABLE STATE
AND LOCAL CODES
IN THE ABSENCE OF LOCAL CODES OR REGULATIONS
REFER TO CURRENT STANDARDS.
WARNING - CAUTION
●
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal
injury or loss of life.
●
Installation and Service must be performed by a Furrion
recommended installer, service agency or gas supplier.
The following instructions apply to the most common type
of installation for Furrion F2GWH Water Heater. Consult
with Furrion Technical Support or Engineering department
if you have any additional questions regarding your specific
installation/application.
IMPORTANT!
For proper operation this water heater requires a minimum
water flow of .80 Gallon per Minute (gpm) for each Hot
Water faucet it supplies.
Select a Suitable Location
The water heater is designed to be installed on a floor or a
fixed platform with access to water, LP gas and a 12VDC
electrical connection from the back. It is recommended that
the F2GWH be located as near the center of the coach as
possible.
●
DO NOT INSTALL IN AN AREA WHERE ONE OR
BOTH THE INLET AIR VENT AND FLUE VENT CAN
BE COVERED BY A DOOR OR ACCESS PANEL WHEN
OPENED.
●
DO NOT INSTALL WHERE THE FLUE VENT IS CLOSER
THAN ONE FOOT IN ALL DIRECTIONS FROM ANY
WINDOW OR OPENING INTO THE VEHICLE.
●
DO NOT INSTALL THE WATER HEATER OR ANY OTHER
APPLIANCE WHERE IT CAN VENT INTO AN AREA
COVERED BY AN AWNING, CANOPY OR ANY OTHER
ENCLOSURE.
NOTE: The water heater can be installed under an RV roll-out/
retractable type awning providing the awning does not have an
enclosure such as a screen room and/or some type of “walled
enclosure”.
Site Preparation
To install on carpeted area you must install a metal or wood
panel under the water heater that extends at least 3 inches
beyond the width and depth of the unit. If water leakage can
result in damage to the adjacent area, install a drain pan that
can be drained to outside of the vehicle, under the water
heater.
Verify that a clearance of 1 inch will remain after installation
between the top surface of the water heater and any
combustible material. Zero inch clearance is acceptable for the
sides.
Make sure that the front edge of the opening is surrounded by
a solid frame to firmly anchor the water heater; if needed, build
an appropriate frame using 2" X 2" elements.
The rough opening for the F2GWH should be 13" X 13" with
right angle corners. The exterior wall opening must be the
same dimensions with no radius corners.
Ensure that electrical water and gas connections from the
vehicle are in place for installing the unit.
Allow sufficient length and flexibility in the electrical, water and
gas lines to reach the connections while the unit is partially
inserted into the opening.