FULTON Reliance 1000, Инструкция по установке и эксплуатации

Страница: 8 / 60

© The Fulton Companies 2012
INSTALLATION
RLN-IOM-2012-1205
SECTION 2
2-2
!
WARNING
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes and
regulations.
Crystalline silica may be present
in components of this equipment.
Exposure to crystalline silica may
pose signifi cant health hazards,
including but not limited to eye and
respiratory system damage. Per
the Centers for Disease Control and
Prevention (CDC) and Occupational
Safety and Health Administration
(OSHA), appropriate personal
protective equipment must be worn
to minimize exposure to hazardous
substances. Refer to most current
guidelines off ered by the CDC and
OSHA for more information, including
personal protective equipment
recommendations.
4
CAUTION
This boiler is certifi ed for indoor
installation only.
This boiler is not designed for use in
systems where water is continuously
replenished. The warranty is valid for
closed loop systems only.
Fulton cannot be held responsible for
the selection, engineering, installation,
or sizing of any additional equipment
or components of the hydronic heating
system.
A qualifi ed engineer must be consulted
for equipment selection and heating
system components.
Product Overview
Prior to the performance of installation, operation, or maintenance procedures,
personnel should become familiar with the equipment (Table 1 and Figure 1) and
its components.
The Fulton Reliance hot water boiler is an automatic, fuel-fi red, high-effi ciency
boiler. The boiler can either be of the sealed combustion/direct vent type or
utilize conventional combustion air intake and fl ue methods.
The boiler is capable of sidewall venting when the appropriate venting materials
are used, and when permitted by local code requirements. It features low
emission pre-mix combustion with pulse width modulation and fully automatic
safety controls.
The Fulton Reliance boiler is constructed to ASME Section IV and certifi ed to
Underwriters Laboratories (UL) 795 Issue 2006/10/27 Edition 6 Standard for
Safety Commercial-Industrial Gas Heating Equipment. All Reliance boilers are
hydrostatically tested, test fi red and shipped as a complete packaged unit.
This boiler is to be installed as part of a hydronic heating system. A qualifi ed
engineer must be consulted for the selection of the equipment and components
of the heating system. Various system conditions can result in incorrect heat
distribution to users of the heating system.
Each Reliance Boiler is supplied with the following:
§ Outer cabinet utilizing an air gap as insulation
§ Integrated combustion supervision and temperature operating control
§ Operating and high temperature dual temperature probe
§ Low water fl ow switch
§ Fully matched modulating premix combustion system including burner,
blower and fuel train controls.
§ ASME pressure relief valve
§ Instruction manual
§ Wiring diagram
§ Combustion Air Adapter
§ Temperature and pressure (T&P) gauge
The customer should examine the equipment for any damage. It is the
responsibility of the installer to ensure all parts supplied with the equipment are
fi tted in a correct and safe manner.