Since the lens has been changed, we need to make sure the markings are adjusted to the new lens.
Mark Adjustment
1.
Run the mark adjustment to verify that the calibration process was successful.
2.
Set a speed of 100mm/sec and input the lens size you are using.
3.
Place a piece of test material under the laser for marking.
Note: Preview the square before proceeding to ensure only test material is marked.
4.
Select “Mark Square”.
5.
Measure the marked square and input the measurements into the boxes.
Note: The top left corner of the square is cut off intentionally.
6.
Select “Save Mark Adjustment”
42