11
Spindle cover
The spindle cover is provided to access the
spindle when installing or removing a diamond
disc (10).
1.
Simply loosen the spindle cover knob (3)
and slide the spindle cover to expose the
spindle (fig. 3).
2.
Close the spindle cover and tighten spindle
cover knob (3) before operation.
Note:
Remove the side handle (4) to allow full movement of the spindle cover.
SET-UP & PREPARATION
WARNING!
Ensure the tool is switched off and disconnected from the
power supply before performing any of the following operations.
Fitting the side handle (4)
For safety reasons you must only use the wall
chaser with the side handle (4) fitted.
1.
Firmly attach the side handle by rotating
anti-clockwise (left-hand thread) (fig. 1).
Fig. 1
Spindle lock button (9) (fig. 2)
The spindle lock button is provided to prevent
the spindle from rotating when installing or
removing a diamond disc (10). Operate the
spindle lock button only when the tool is
turned off, the tool is unplugged, and the disc
has come to a complete stop.
Fig. 2
25
29
20
15
10
5
3
Spindle
Fig. 3
