16
MAINTENANCE
• Keep the ventilation vents of the wall chaser clean at all times.
• To prevent stone-dust build-up inside the wall chaser when used over extended periods,
the motor needs to be cleaned periodically by blowing out with low pressure compressed
air (through the vent slot at the rear end of the motor casing). This should not be done
indoors. Ensure appropriate safety gear is worn when blowing tool with compressed air.
• If the enclosure of the wall chaser requires cleaning, do not use solvents but a moist soft
cloth only. Never let any liquid get inside the wall chaser; never immerse any part of the
wall chaser into a liquid.
Carbon brushes
When the carbon brushes wear out, the wall chaser will spark and/
or stop. Discontinue use as soon as this happens. They should be
replaced prior to recommencing use of the wall chaser. Carbon
brushes are a wearing component of the wall chaser, therefore not
covered under warranty. Continuing to use the wall chaser when the
carbon brushes need to be replaced may cause permanent damage to the tool. Carbon
brushes will wear out after many uses but when the carbon brushes need to be replaced,
take the wall chaser to an electrician or a power tool repairer for a quick and low cost
replacement. Always replace both carbon brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the wall chaser by an unauthorised person or by mishandling of the wall chaser.
Spare Parts
Limited spare parts are available subject to availability. Please contact your local Bunnings
Special Orders Desk to order the required spare parts.
