FULGOR OVFS9-10, Инструкция по использованию и уходу, Страница: 13 / 36

13
2. MAINTENANCE
WARNINGS:
Before carrying out any maintenance or transformation operations, turn off the electricity supply and
close the gas upstream from the appliance. If components and/or accessories need replacing, only
exclusive originals must be used. Servicing should be carried out only by authorised service
personnel.
2.1. FLEXIBLE HOSE GAS SUPPLY
The condition of the flexible hose gas supply pipe should be checked periodically (once a year) and
replaced if there are signs of cracking, cuts, scratches or burns, or if it the hose is no longer flexible but
hard. If the hose is damaged, turn off the gas supply and contact your authorised service provider for
a replacement hose. (This is not covered under warranty).
2.2. ELECTRICITY SUPPLY CABLE
If the electricity supply cable needs replacing, please remember that
this is an X type of connection, this replacement must be carried out by
an authorised technician. Only use type HO5FRR-F, the earth wire
(yellow/green) must be at least 2 cm longer than the other two
wires(B). This ensures that electrical safety is guaranteed should the
wire accidentally be pulled. For the cookers with gas oven and electric
grill, use a HO5RR-F 3x1 mm
2
cable, for the cookers with electric oven
and grill use a HO5RR-F 3x1.5 mm
2
cable with outside diameter max.
9 mm.
2.3. ACCESS TO ELECTRICAL/GAS COMPONENTS
To carry out maintenance and/or replace the electrical components fitted in the back of the cooker (e.g.
light bulb holder, rotisserie, supply cable, electric ignition generator, resistances) the rear protection
panel must be removed by unscrewing the screws that fix it to the sides. To carry out maintenance and/or
replace the electrical components fitted to the front panel (e.g. control panel, taps, thermostat, timer,
etc), you must proceed as follows:
- in all models where fitted, remove the flue pipe;
- remove the hob grids and burners;
- unscrew the screws that fix the cups to the hob
and, for models with safety device, also remove
the nuts that block the thermocouples;
- unscrew the 2 front upper or front side screws
that fix the hob and then lift it;
- remove the knobs and remove the screws that
block the gas train to the front control panel,
remove the gas train taking care not to damage
any pipes or thermocouples.
- to reassemble follow these instructions in
reverse order.
2.4. REPLACING THE THERMOSTAT TAPS
If a tap or a thermostat needs replacing, first follow the instructions given in paragraph 2.3. (access to
electrical/gas components), then remove the nut that blocks the supply pipe to the burner, the
thermocouple nut and the screws that fix the tap or the thermostat to the gas train. Besides the tap or
the thermostat, it is also important that the gas-sealing gasket is replaced. After maintenance, ensure
that there are no leaks using a specific instrument or, more simply, soapy water.
N.B. Authorised personnel must only carry out these maintenance operations.