FULGOR OVFS9-10, Инструкция по использованию и уходу, Страница: 11 / 36

11
1.8. GAS CONVERSION OF THE HOB BURNERS
This cooker is suitable for use with Natural Gas or Universal
LPG. All cookers are Natural gas ready. Appliances will be
converted to LPG if notified at the time of order. Otherwise a
qualified gas fitter must change the jets over as stated below.
The LPG Jets are included. When converting from one gas to
another type of gas the data plate must also be replaced.
Burners: auxiliary, semi-rapid, rapid, triple crown, fish.
These burners are all fitted with injectors with shapes to
allow a primary input of air gauged for each type of gas;
therefore, air regulation is not required. For converting
from one sort of gas to another, proceed as follows: remove
the grids, and burners as described in section 3.8 ; replace
the holed injectors as indicated
depending on the type of gas used, referring to table 1;
replace the burner supports, flame diffusers, covers & grids;
regulate the minimum output following the instructions
given in paragraph 1.8. When converting from Natural Gas
to Universal LPG ensure that the NG regulator is removed and replaced with the Test Point Assembly.
When converting from Universal LPG to Natural Gas, fit the Natural Gas regulator supplied with the
conversion kit.
1.9. REGULATING THE MINIMUM OUTPUT OF THE HOB BURNERS
Norma 1/ Valve Taps
Ignite the burners to the maximum position, remove the knob and insert a small flat 2.5mm screwdriver
into the rod or through the holes on the side of the control dashboard, depending on the type (fig. 8 A/B
following page). Loosen the by-pass screw by two turns in an anti-clockwise direction and rotate the
rod to the minimum position. Adjust the previously loosened screws until a reduced but stable flame is
acquired, even when rapid changes are made from the maximum to the minimum position with the
burner cold. If there are safety taps, let the burner run on minimum for a few minutes to ensure that
the device does not cut in. If it should, increase the minimum.
N.B. For LPG settings, the burner minimum must be set by screwing the tap by-pass all the
way down.
1.10. GAS CONVERSION OF THE OVEN BURNERS AND GAS GRILL
This cooker is suitable for use with Natural Gas or Universal LPG. When converting from one gas to
another type of gas the data plate must also be replaced. Oven burners:
to have access to the oven injector proceed as follows:
Open the oven door and remove the oven base;
Unscrew the screw that fixes the burner inside the oven (in the giant oven it is fixed to the
side wall of the muffle, and in the other models it is fixed to the tab in the front part) and
remove the burner from its housing paying attention not to damage the knob fixed to it;
Replace the holed injector depending on the type of gas used, refer to table 1; Replace the
burner in its original position.