53 - Starting the Tablet PC
•
The suspend action of the Suspend/Resume switch may be disabled to prevent accidental
interruption. If this is the case, sliding the Suspend/Resume switch will not suspend system
operation as described here. (In this case, sleep mode can only be achieved using the system
software). Contact your local help desk or reseller if your system configuration is not suitable.
•
If your system is equipped with a PC Card that allows you to connect to a wired or wireless network,
you may be logged off the network after a period of inactivity while system operation is suspended.
Contact a network administrator or help desk, or call Fujitsu Service and Support at 1-800-8Fujitsu
(1-800-838-5487) for details on your network log-off parameters.
Resuming Operation
To resume operation from either Sleep or Hibernate modes, slide the Suspend/Resume switch.
•
From Sleep mode
Status lights indicate that the system state is changing. It may take up to a minute before the system
returns to the On state and system operation resumes. Note that the display turns on shortly before
the pen becomes active due to the power-up sequences observed by the system.
•
From Hibernate mode
Active data is read from the hard disk drive, and the system returns to the On state after a short time
.
Use the system as you normally would once system operation resumes.
All programs resume at the point where execution stopped when system operation was suspended.
N
OTE
THAT
POWER
TO
SEVERAL
SYSTEM
COMPONENTS
MUST
BE
RESTORED
BEFORE
SYSTEM
OPERATION
RESUMES
. A
LLOW
SUFFICIENT
TIME
FOR
SYSTEM
OPERATION
TO
RESUME
BEFORE
ATTEMPTING
TO
USE
THE
SYSTEM
. I
F
YOUR
SYSTEM
USES
H
IBERNATE
MODE
,
IT
WILL
TAKE
LONGER
TO
RESUME
OPERATION
AS
COMPARED
TO
USING
S
LEEP
MODE
. T
IME
IS
NEEDED
TO
READ
DATA
FROM
THE
HARD
DISK
DRIVE
.
ST6000.book Page 53 Monday, November 3, 2008 10:23 AM