Fujitsu SPARC Enterprise T2000, Руководство по обслуживанию, Страница: 79 / 174

Chapter 3 Server Diagnostics 3-39
3. If a device detected by POST is a single DIMM and the same DIMM is not
detected by PSH, follow the procedure in Section 3.4.5.1, “Correctable Errors for
Single DIMMs” on page 3-37 .
After the detected devices are repaired or replaced, return POST to the default
minimum level.
3.4.6 Clearing POST Detected Faults
In most cases, when POST detects a faulty component, POST logs the fault and
automatically takes the failed component out of operation by placing the component
in the ASR blacklist (see
Section 3.7, “Managing Components With Automatic
System Recovery Commands” on page 3-46 ).
After the faulty FRU is replaced, you must clear the fault by removing the
component from the ASR blacklist. This procedure describes how to do this.
1. After replacing a faulty FRU, at the ALOM CMT prompt use the
showfaults
command to identify POST detected faults.
POST detected faults are distinguished from other kinds of faults by the text:
deemed faulty and disabled
, and no UUID number is reported.
Example:
If no fault is reported, you do not need to do anything else. Do not perform the
subsequent steps.
sc> setkeyswitch normal
sc> setsc diag_mode normal
sc> setsc diag_level min
sc> showfaults -v
ID Time FRU Fault
1 APR 24 12:47:27 MB/CMP0/CH2/R0/D0 MB/CMP0/CH2/R0/D0
deemed faulty and disabled