Fujitsu PRIMEQUEST 400 Series, Руководство по установке, Страница: 245 / 446

C122-E001-10EN 4-59
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
-A authPassword: Specifies an authentication password (eight or more characters).
The password must be the same as the setting in the manager.
This option is valid when authentication is included in the security
level specified by the -l option. It can be omitted if the
authentication is not included.
-x privProtocol: Specifies the protocol used to encrypt SNMPv3 messages.
Currently, only DES is supported as a privacy protocol. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
-X privPassword: Specifies an encryption password (eight or more characters). The
password must be the same as the setting in the manager. If
encryption is included in the security level specified by the -l
option, this option is valid; otherwise, it may be omitted.
Example: When you want to send SNMPv3 traps with the "PRIMEQUEST" account,
with authentication and encryption enabled, to port 162 of the manager
with IP address 192.168.1.10
After setting the trap transfer destination, restart snmpd by executing the following
command:
After snmpd has been reactivated, activate PSA.
#trapsess 3 -e 0x800007e58026577a9f421950a4 -u PRIMEQUEST -l authPriv
-a MD5 -A 00000000
-x DES -X 11111111 192.168.1.10:162
##SNMPv3 trap setting
#/etc/init.d/snmpd restart
#/etc/init.d/y30FJSVpsa y30FJSVpsa stop
#/etc/init.d/y30FJSVpsa y30FJSVpsa start