System expansions
Installing a new assembly kit (for expansion
from 4 to max. 8 drives)
If you wish to upgrade your device to up to 8 drives, replace the standard assembly
kit C78 with the optional expansion assembly kit C76.
In addition to the cable for the basic con
fi
guration, you will also need an expansion cable.
Assignment of expansion assembly kit:
EP0 / P0
EP1 / P1
EP2 / P2
EP3 / P3
EP4 / P0*
EP5 / P1*
EP6 / P2*
EP7 / P3*
Assignment of expansion assembly kit with
connected connectors:
Basic con
fi
guration cable:
•
Slot EP0 = Connector P0 (Boot-HDD)
•
Slot EP1 = Connector P1
•
Slot EP2 = Connector P2
•
Slot EP3 = Connector P3
Expansion cable:
•
Slot EP4 = Connector P0*
•
Slot EP5 = Connector P1*
•
Slot EP6 = Connector P2*
•
Slot EP7 = Connector P3*
Replacing the assembly kit
•
Requirements:
There are not any hard disk drives installed in the drive bays.
Otherwise you must
fi
rst remove the hard disk drives.
•
The casing is open (see
"Opening the casing", Page 33
).
•
The hard disk fan is removed (see
"Remove the hard disk fan", Page 67
).
If you wish to use an installation kit for your hard disks which is other than that which
was installed in your device in the factory, proceed as follows:
Only the relevant components are shown in the following illustrations
for reasons of simpli
fi
cation.
Fujitsu
51
Содержание CELSIUS M740
Страница 1: ...System Operating Manual FUJITSU Workstation CELSIUS M740 CELSIUS M740power ...
Страница 3: ......