Fujitsu 565Tx, Руководство пользователя

Страница: 120 / 179

S e c t i o n F o u r
108
C A U T I O N
Before you install or remove the memory
upgrade module, save changes and close
all files. Turn power off to your notebook
including turning off the power switch.
(See Power Off on Page
24
.)
instructions in steps 7 through 11 of the
instructions for Installing a Memory
Upgrade Module.
To Remove a Memory Upgrade Module:
1. Perform steps 1 through 5 of Installing
a Memory Upgrade Module.
2. Pull clips sideways from each side of the
memory upgrade module. (Figure 4-10).
3. While holding clips out, remove the module
from the slot by lifting it up and pulling
towards the front edge of your notebook.
4.Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover by following the instruc-
tions in steps 10 and 11 of the instructions
for Installing a Memory Upgrade Module, or
install a new memory upgrade module and
then replace the cover by following the
To do so:
1. Turn on power.
2.Enter the setup utility by pressing the Esc key
and then the F2 key as soon as the Fujitsu
logo appears on the screen. (See page 53.)
3. The system memory and the extended
memory capacity, as detected by your note-
book during the Power On Self Test (POST),
are displayed at the bottom of the Main
Menu screen.
Total RAM System Extended
Installed Memory Memory
32 MB 640 KB 32128K
48 MB 640 KB 48512K
64 MB 640 KB 64896K
96 MB 640 KB 97664K
If the total memory displayed is not what you
believe it should be, check that your memory
upgrade module is properly installed. If it is
properly installed and the capacity is not
correctly recognized,see the Troubleshooting
Section starting on page 114.
C A U T I O N
The memory upgrade module can
be severely damaged by electro-static
discharge (ESD). Be sure your are properly
grounded when handling and removing
the module.
Checking the Recognition of
New Memory Capacity
When you have changed memory capacity by
adding or removing a memory upgrade
module, be sure to check that your notebook
has recognized all of the memory. When you
turn the power on to your notebook for the
first time after making the change check the
memory capacity. It is displayed while the
system is booting, but it will probably go by
too fast for you to read. Instead check memory
capacity by looking at the Main menu of the
BIOS setup utility.