Fujikura FSM-50S, Инструкция по эксплуатации

Страница: 84 / 92

80
Error Message List
Error
Message
Reason Solution
Insufficient fiber
cleaning.
Dust or dirt on the fiber surface results in bad splice
loss and low tensile strength.
• Clean the fiber surface sufficiently.
• Do not clean the fiber after cleaving to prevent dust
on the fiber end-face.
• Avoid any contact with the fiber end-face.
Bad fiber
end-face.
• Check the condition of fiber cleaver. If the blade is
worn, rotate the blade to a new position.
• Confirm the [Cleave Limit] setting. 2.0° or less is
recommended.
Dust or dirt is on
the V-groove or
the clamp chip. Dust or dirt on the V-groove or clamp chip causes poor
fiber movement during fiber stuffing. Clean them
periodically.
Dust or dirt is on
the lens or mirror Execute the [Dust Check]. If dust or dirt exists, clean
the lenses or mirrors.
Bad electrode
condition. Replace the electrodes if they appear worn (rounded
tip shape), dirty or bent.
Inadequate arc
power. Calibrate the arc power with the [Arc Calibration]
function.
Using unsuitable
splice mode Select a suitable splice mode for the fibers to be
spliced.
[Loss Limit] is set
too low.
Increase [Loss Limit] to an adequate limit.
Fibers were
spliced after Error
08 was canceled.
Select the appropriate splice mode from the Other
modes.
Inadequate arc
parameters in
other splice modes
Confirm the arc parameters are adequate to splice the
fibers.
High
Estimated
Loss
Inadequate
estimating
parameters in
Other mode Confirm the estimating parameters are adequate to
estimate the loss. The MFD mismatch function does
not work for certain types of specialty fibers. In these
cases, set the [MFD Mismatch] to “OFF”.