FujiClean CE Series, Руководство пользователя

Страница: 19 / 47

Step 3. Reset the Recirculation
Control Valve (grey valve) to the
original position.
Step 4.
Aerate one side of the
chamber by turning the
Aeration Balance Control Valve
(blue valve) fully one way. Wait
for one minute, and then turn
the valve fully to the opposite
direction. Wait for another
minute, and then reset the valve
to the original position
Step 5.
Repeat Steps 2 - 4 three
times.
Step 6.
Final repeat of Step 2.
12. Backwash and Sludge
Transfer. (Recommended
frequency: 1x every 6 months)
Perform a backwash and sludge
transfer operation.
Excessive biofilm growth on the
contact and filter media
(Chambers 2 and 3) may cause
partial clogging or short
circuiting and deteriorate the
performance of the system. It is
essential to carry out this
backwash operation and sludge
transfer at every maintenance
visit.
Step 1. Shut off the Effluent
Air-lift Pump by turning the
Effluent Control Valve (white
valve) clockwise until it
won't turn any more.
Step 2. Transfer the sludge
on the bottom of the
aeration chamber by turning
the Recirculation Control
Valve (grey valve) to 70-80
and wait for one minute.
Step 8. Flush the Effluent
Control Valve (white) by
rotating the valve back and
forth from 0 to 100 several
times.
Step 9.
Reset the Recirculation
Control Valve (grey valve) and
the Effluent Control Valve (white
valve) to their original positions.
Make sure that the aeration is
working properly.
Step 10.
Poke and penetrate
into the anaerobic filtration
media with a small diameter
PVC pipe (e.g. ½-inch) gently
and evenly throughout
Anaerobic Filtration Chamber
for media degassing. This is a
simple but essential procedure
to assure uniform media contact
and filtration.
CE Systems CEN Systems
17