69
Chapter 7 Finisher
4.
While holding the tabs on the new staple cartridge,
push in the cartridge until it seats.
Note
Make sure that the
marks are aligned.
5.
Push the Saddle Stitch Unit "3" gently into the
machine until it stops.
6.
Close the cover.
7.3.2
Staple Faults
Follow the procedures on the following pages when printed sheets are not stapled or staples are bent.
Contact your local Fuji Xerox representative if the problem persists after you have tried the following solu-
tions.
If printed sheets are stapled as shown in the figures below, contact your local Fuji Xerox representative.
Important
Depending on the type of paper being stapled, the stapled nails may be bent. If the bent nails are stuck
inside the machine, they may eventually cause paper jams.
When you open the cover of the staple cartridge, remove any bent staple. Otherwise it may cause staple
jams. Use the cover of the staple cartridge only when removing jammed staples.
Unstapled
Bent staple
One side of staple rising up
Staple bent in reverse direction
Entire staple rising up
Staple rising up with
center pressed in
Flattened staple
