- 47 -
INZ-TN2ZSVS-E
4.3.2 Average output time
Average corrected time can be set in this mode.
(1) Move the cursor to <2. Average time> using the
key, and press the
key.
The screen switches as shown at right.
• “01 to 59 minutes (in steps of 1 minute)” or “01 to 04 hours (in steps of 1 hour)”
Setting contents
“01 hour”
Initial value
(2) Move the cursor to the channel (CH) to be set using
the
key.
Press the
key, and the cursor moves to the time to
be set.
(3) Move the cursor to “Hour” and “Minute” using the
key, and enter numeric values using the
key.
Move the cursor to the “numeric value” using the
key again, change the value using the
key, and
then press the
key.
(4) Make the setting for other channels in the same man-
ner.
The setting has now been completed.
• The message shown at right is displayed if average cor-
rected value is not selected in “4.3.1 Selecting output
type.”
• Sampling cycle is 30 seconds.
• The average of the values from the current time to before
the time of setting is output at intervals of 30 seconds.
Accurate average value can be obtained when the set time
elapses after the data is input.
Caution on setting
ESC
ESC
ENT
,
ENT
,
ENT
,
,
Setting complete
