Fuji Electric ZSS-8 Series, Инструкция по эксплуатации

Страница: 24 / 119

- 14 -
INZ-TN8ZSS-E
(12) Cable connection
Connect the cable between the transmitter unit and the receiver unit, and the cable be-
tween the receiver unit and the control unit. (“4.10 Cable connection”)
P.21, 22
↓
(13) Turning on the control unit
↓
(14) Light intensity adjustment
Adjust the light intensity to as close to the value on nameplate as possible.
*This may be difficult when you adjust the angle while the furnace is in operation.
↓
(15)
Optical path length setting
Enter the optical path length on the control panel. (“6.5 Parameter setting”)
P.63 to 67
↓
(16) Analog signal wiring P.28
↓
(17) Output item setting
Select the items to be transmitted. (“6.8 Analog output”)
P.63
↓
(18) Analog signal adjustment
Make a analog output setting in reference to “6.9 Fine adjustment of analog output val-
ue”.
P.63 to 67
↓
(19) Analog input setting
If you use external sensors for gas pressure, gas temperature, gas flow rate, O
2
, and /or
H
2
O, make necessary settings for them. For the items with no external sensor, set the
parameter to fixed value. Gas temperature, O
2
, and HCl have to be properly set for
measurement.
If there is a difference between the gas temperature during furnace suspension and the
fixed gas temperature, measurement error may occur. (“6.7 Analog input”)
P.63 to 67
↓
(20) Other parameters setting P.83
↓
(21) Digital signal wiring P.28
↓
(22) Analog signal adjustment (as needed) P.84
↓
(23) Alarm output check (as needed) P.87