
51
NOTE: Adjustment is through small hole in end cap.
GENERAL MAINTENANCE
WARNING:
The effect that the safety level of the equipment can be maintained only if it is
examined regularly for damage and wear. The components which are most susceptible to wear:
Belt
、
Idler
、
roller
、
Desk
、
Tread-belt.
Belt and Deck
- Your treadmill uses a very high-efficient low-friction deck. Performance is
maximized when the deck is kept as clean as possible. Use a soft, damp cloth or paper towel to
wipe the edge of the belt and the area between the belt edge and frame. Also reach as far as
practical directly under the belt edge. This should be done once every other month to extend
belt and deck life. Use water only - no cleaners or abrasives. A mild soap and water solution
along with a nylon scrub brush will clean the top of the textured belt.
Allow the belt to dry
before using.
Belt Dust
- This occurs during normal break-in or until the belt stabilizes. Wiping excess off
with a damp cloth will minimize buildup.
General Cleaning
- Dirt, dust, and pet hair can block air inlets and accumulate on the running
belt. On a monthly basis: vacuum underneath your treadmill to prevent buildup.
UNPLUG THE MAINS SUPPLY BEFORE DOING ANY CLEANING OR MAINTENANCE
!
BELT ADJUSTMENTS
Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very important
though for joggers and runners in order to provide a smooth, steady running surface.
Adjustment must be made from the rear roller with the 6 mm Allen wrench (132) provided in
the parts package. The adjustment bolts are located at the end of the step rails as shown in the
diagram below.
Note: Adjustment is through small hole in end cap.
Tracking / Tension Adjustment
Tighten the rear roller only enough to prevent
slippage at the front roller. Turn the tread-belt
tension adjusting bolts 1/4 turn each and inspect
for proper tension by walking on the belt and
making sure it is not slipping or hesitating with
each step. When an adjustment is made to the belt
tension, you must be sure to turn the bolts on both
sides evenly or the belt could start tracking to one
side instead of running in the middle of the deck.
DO NOT OVERTIGHTEN
–
Over tightening will cause belt damage and premature bearing
failure. If you tighten the belt a lot and it still slips, the problem could actually be the drive belt
-located under the motor cover - that connects the motor to the front roller. If that belt is loose it feels similar
to the walking belt being loose. Tightening the motor belt should be done by a trained service person.
Содержание LB 600
Страница 25: ...25 EXPLOSIONSZEICHNUNG...
Страница 56: ...56 EXPLODED VIEW...
Страница 62: ...62 NOTES...
Страница 63: ...63 NOTES...