Place batteries with positive “+” and negative “-“ terminals into compartment and make
sure they match the indicated terminals in the compartment.
Close the battery cover by gently sliding it into the compartment and pressing it into
place..
See Figure 3.
Note
：
：
：
：
When the LCD display shows “Low Battery” signal
,the batteries must be replaced for
accurate readings.
See Figure 4
Do not use rechargeable batteries (voltage 1.2V). They are not suitable for this product,
can damage the monitor and will cause inaccurate readings to be obtained.
Remove the batteries if the monitor will not be used for six month or longer to avoid
damage from the possibility of leaking batteries.
All the measurements will remain in the memory should the batteries become drained,
removed, or replaced.
Figure 3 Figure 4
Clock Adjusting and Unit Change
During the monitor is turned off, if you continually press and the “SET” buttons for about 5
seconds, the number of the YEAR signal will begin to blink on the LCD display. Press the
“M” (for memory) button to change the YEAR. Each time when you press the “M” button,
it will change one YEAR forward.
When the YEAR is set up, if you continually press and release the “SET” button, the
MONTH signal will begin to blink. Press the “M” button to change the MONTH. Each time
when you press the “M” button, it will change one MONTH forward.
When the MONTH is set up, if you continually press and release “SET” button once, the
