Frost Fighter IHS 1500, Инструкция по установке, эксплуатации, техническому обслуживанию и перечень запасных частей

Страница: 13 / 30

MAINTENANCE AND SERVICE
WARNING Operation and adjustment of the burner requires technical knowledge and the use of
combustion test instruments. Do not tamper with the burner or controls. Failure to
comply could result in failure or the burner or system, resulting in severe personal injury,
death or substantial property damage.
ANNUAL SERVICE
Have the burner inspected; tested and started at least annually by a qualified service technician. This
annual test/inspection should include at least the following:
o Clean burner and blower wheel (to remove lint and debris).
o Test ignition and combustion and verify air damper settings.
o Test fuel lines and all connections
o Inspect combustion air and vent systems.
o Oil motor (if not permanently lubricated).
MONTHLY MAINTENANCE
o Observe combustion air openings and vent system for integrity. Openings must be clean
and free of obstructions.
o Check the fuel lines and fittings to verify there are no leaks.
o Observe burner ignition and performance to verify smooth operation.
o Shut the system down if you observe abnormal or questionable operation. Call a
qualified service agency for professional inspection and service.
o Grease the main supply blower bearings.
CLEANING THE HEAT EXCHANGER
To clean the secondary of heat exchanger remove the clean out panel located above the burner. This
gives you access to the heat exchanger. Remove the exchanger panel and flue baffles. With a brush
clean out the secondary walls. When re-installing the exchanger panel replace the gasket and re-apply
high temperature silicone rated to 800F. To clean out the main drum, remove the burner and with a brush
clean the sides of the drum. To re-install the burner replace the gasket and insure the burner inserts into
the exchanger 3 ¾ inches. Run the unit at full fire.
12